A fastener by fastener tutorial for testing and removing a faulty ignition switch on a Honda Accord.
In part one I cover how to cause an intermittent switch to act up, test it for continuity to verify it's faulty, and how to remove the cylinder assembly from the vehicle so the electrical switch can be removed.
In part two I cover the 1990s to 2000s Honda ignition switch recalls and the special part numbers that go with them and reinstallation of the cylinder assembly to the vehicle.
The shear bolt diameter and thread pitch is M8 X 1.25.
Part 2: http://www.youtube.com/watch?v=h0pYfY31h5Y
Link to the recall PDF with installation diagrams:
"Welcome To The Show" Kevin MacLeod (incompetech.com) Licensed under Creative Commons: By Attribution 3.0 License
Due to factors beyond the control of Bushougoma, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Bushougoma assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Bushougoma recommends safe practices when working with the tools or equipment seen or implied in this video. No information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Bushougoma.
94-97 Honda Accord Ignition Switch Replacement Part 1